Filter
Top Products
26
Disassembly - All Frame Styles
1. Remove the hex screws, coved washers and
locknuts that secure the seat adjustment plates
to the seat frame.
Short and Medium Frames Only:
NOTE: When short and medium seat frames are
in their FORWARD POSITION ONLY (15 and 17-
inches respectively), the rear outside coved
washers, button screws and locknuts of the rear
arm brackets will NOT be used. The back cane
mounting brackets will mount over the top of
the rear arm brackets (FIGURE 1). Retain the un-
used coved washers, button screws and lock-
nuts for future use.
1. If assembling the short and medium seat frames
into the forward position, remove the REAR but-
ton screws and locknuts that secure the rear
arm brackets to the seat frame.
Reassembly - All Frame Styles
1. Reposition the back canes to the desired seat
depth and reassemble.
SEATPROCEDURE 3
This Procedure includes the following:
Seat Depth Adjustment - Short Seat Frame 15-
18-inches, Medium Seat Frame 17-20-inches,
Long Seat Frame 21-22-inches
Seat Width Adjustment
Seat-to-Floor Height Adjustment
WARNING
After ANY adjustments, repair or service and
BEFORE use, make sure all attaching hardware
is tightened securely - otherwise injury or dam-
age may result.
FIGURE 1 - SEAT DEPTH ADJUSTMENT -
SHORT SEAT FRAME 15-18-INCHES,
MEDIUM SEAT FRAME 17-20-INCHES,
LONG SEAT FRAME 21-22-INCHES
SHORT 18 17 16 15 SEAT DEPTHS
MEDIUM 20 19 18 17 MEASURED IN
LONG 22 21 N/A N/A INCHES
FRAME SEAT ADJUSTMENT PLATE/
STYLE BACK CANE POSITION FOR
CORRESPONDING SEAT DEPTHS
Seat
frame
Seat adjustment plate
Rear arm
bracket
Remove this
button screw
and locknut
when in the
forward
position
Back cane
Hex
Screws,
Coved
Washers,
Locknuts
S
E
A
T
PROCEDURE: 545637
Tilt-in-Space ✓ ● ✓✓N/A ✓
Back Angle ✓✓● ✓ N/A ✓
Rear Wheels ✓✓✓● N/A ✓
Seat Depth ✓✓N/A ✓ ● ✓
Wheel Locks N/A ✓✓✓✓●
NOTE: When adjusting the shaded area in the
left hand column, refer to the
✓✓
✓✓
✓ procedure to
ensure the proper stability, safety and handling
of the wheelchair.
Limit Stops
Tilt-in-Space
Back Angle
Rear Wheels
Seat Depth
Wheel Locks
SEAT DEPTH ADJUSTMENT - SHORT SEAT
FRAME 15-18-INCHES, MEDIUM SEAT FRAME
17-20-INCHES, LONG SEAT FRAME 21-22-
INCHES (FIGURE 1)
NOTE: This procedure refers to NON-RECLINER
seat frames only. For recliner seat frames, refer
to PROCEDURE 9 of this manual.
WARNING
Changing the seat depth of the wheelchair
changes the stability of the wheelchair. To main-
tain stability, reposition the rear wheels towards
the rear of the wheelchair BEFORE using the
wheelchair.
To maintain the stability of the wheelchair when
moving the rear wheels to ANY forward posi-
tion, the amount of tilt MUST be limited by ad-
justing the limit stops on the gas cylinders to
prevent the wheelchair from tipping onto the
anti-tippers.