Filter
Top Products
22
NOTE: If the inside T-arm post does not slide
up and down in the outside T-arm post as de-
sired, perform one (1) of the following:
A. Tighten - Tightening the set screws on the out-
side T-arm post will make it harder to move the
inside T-arm post up and down.
B. Loosen - Loosening the set screws on the out-
side T-arm post will make it easier to move the
inside T-arm post up and down.
3. Lock the T-arm by flipping the T-arm release le-
ver towards the front of the wheelchair.
FIGURE 5 - ADJUSTING THE T-ARMS - HEIGHT
Width (FIGURE 6)
1. Remove the two (2) phillips screws that secure the
arm pad to the arm tube.
2. Turn the arm pad around and reposition the arm pad
on the arm tube.
3. Re-secure the arm pad to the arm tube with the two
(2) phillips screws.
4. Repeat for the opposite side, if necessary.
FIGURE 6 - ADJUSTING THE T-ARMS - WIDTH
Phillips
Screw
Arm Tube
Phillips Screw
Arm Pad
Depth (FIGURE 7)
1. Remove the two (2) phillips screws that secure the
arm pad to the arm tube.
2. Remove the two (2) socket screws that secure the
arm tube to the T-arm post.
3. Reposition the arm tube on the T-arm post:
A. Desk Length Arms - to one (1) of three (3) posi-
tions depending on the desired arm pad depth.
B. Full Length Arms - to one (1) of five (5) posi-
tions depending on the desired arm pad depth.
NOTE: Additional positions are obtainable by
turning the arm tube 180
o
.
4. Re-secure the arm tube to the T-arm post with the
two (2) socket screws.
5. Reattach the arm pad to the arm tube with the two (2)
phillips screws.
6. Repeat for the opposite side, if necessary.
Socket
Screws
Arm Pad
Phillips
Screw
T-Arm Post
Arm Tube
NOTE: If
necessary, turn
arm tube 180
o
to obtain two
(2) positions.
Phillips Screw
FIGURE 7 - ADJUSTING THE T-ARMS - DEPTH
T-Arm Sockets (FIGURE 8)
1. Remove the rear wheels from the wheelchair. If nec-
essary, refer to the owner's manual supplied with the
wheelchair.
2. Loosen, but do not remove the four (4) hex screws
and washers that secure the T-arm socket to the
T- arm clamp.
NOTE: The T-arm socket will disassemble if the
four (4) hex screws and washers are removed.
3. Slide the T-arm into the T-arm socket until the lock-
ing lever is in the slot in the T-arm socket and an
audible "click" is heard.
A
R
M
S
PROCEDURE 2 ARMS
Set
Screws
T-Arm Release
Lever - Unlocked
Position
Inside T-Arm
Post
Outside
T- Arm Post
T-Arm Release Lever -
Locked Position