Filter
Top Products
17
FRONT RIGGINGS PROCEDURE 1
F
R
O
N
T
R
I
G
G
I
N
G
S
IMPACT GUARDS/CALF STRAP/H-STRAP
(FIGURE 7)
1. Remove the impact guard/calf strap from the pack-
aged container if not already secured to the footrest
assembly.
2. Secure the impact guards to the footrest frame by
wrapping around the footrest tube.
3. Secure the calf strap around the footrest frame be-
tween the footrest supports (over the impact guards,
if attached).
NOTE: When securing the H-Strap, both the top and
bottom section of the H-Strap MUST be secure to the
footrest frame.
Lower Footrest
Assembly
Locknut
Heel Loop
Articulating
Footplate
Spacer
Spacer
Phillips
Screw
Heel
Loop
FIGURE 8 - COMPOSITE/ARTICULATING
FOOTPLATE HEEL LOOP REPLACEMENT
Heel Loop
Screws
Composite
Footplate
Hex Screw and
Coved Washer
FIGURE 7 - IMPACT GUARDS/CALF STRAP/
H-STRAP
Calf-Strap
Impact Guard
H-Strap
ELEVATING LEGREST/CALFPAD
ASSEMBLY (FIGURE 9)
1. Insert the footplate assembly into the calfpad as-
sembly and secure it with bolt and nut.
2. Place legrest/calfpad assembly on the outside of
the wheelchair and insert mounting pin into the
mounting tube on the wheelchair frame.
3. Rotate legrest/calfpad assembly toward the inside
of the wheelchair until it locks in place.
Mounting Tube
Mounting Pin
Footplate
Assembly
Bolt and
Nut
Calfpad
Assembly
Release
Handle
FIGURE 9 - ELEVATING LEGREST/CALFPAD
ASSEMBLY
COMPOSITE/ARTICULATING FOOTPLATE
HEEL LOOP REPLACEMENT (FIGURE 8)
Disassembly
COMPOSITE.
1. Remove the hex screw and coved washer that
secure the lower half of the footrest to the swing-
away footrest assembly.
2. Remove the lower footrest assembly.
3. Remove the phillips screw and locknut that se-
cure the heel loop to the footrest.
4. Slide heel loop off of the footrest.
ARTICULATING.
1. Remove the heel loop screws from the footplate.
Reassembly
1. Replace heel loop.
2. Reverse the disassembly procedures.
NOTE: When securing the heel loop to the foot-
rest assembly, tighten phillips screw until the
spacer is secure.