Filter
Top Products
23
4. Squeeze the T-arm socket the T-arm clamp together
until the socket is flush with the T-arm.
5. While holding the T-arm socket and the T-arm clamp
together, tighten the four (4) hex screws and wash-
ers securely.
6. Press in on the locking lever and lift the T-arm straight
up and out of the T-arm socket.
7. Repeat STEPS 3-6, if necessary until the T-arm slides
in the T-arm socket as desired.
FIGURE 8 - ADJUSTING THE T-ARMS - T-ARM
SOCKETS
REPLACING THE LOCKING LEVER - T-ARMS
(FIGURE 10)
1. Remove the T-arm from the wheelchair. Refer to IN-
STALLING/REMOVING THE T-ARMS in this pro-
cedure of the manual.
2. Remove the phillips bolt and locknut that secure the
existing locking lever to the bottom bracket.
CAUTION
The locking lever is spring loaded. Place your
free hand over the locking lever to prevent the
parts from springing off of the bottom bracket.
3. Remove the existing locking lever and spring
from the bottom bracket.
NOTE: Inspect the spring and replace if necessary.
4. Position the spring on the bottom bracket as shown
in FIGURE 10.
5. Position the new locking lever onto the spring and
the bottom bracket.
NOTE: Make sure the two (2) extended ends of the
spring are inside the notch in the locking lever.
6. Line up the mounting holes in the new locking lever,
spring and bottom bracket.
A
R
M
S
PROCEDURE 2ARMS
Hex Screws
and Washers
T-Arm
Hex Screws and
Washers
T-Arm Socket
ADJUSTING THE TRANSFER ASSISTS AND/
OR SIDE GUARDS - T-ARMS (FIGURE 9)
1. Remove the T-arm from the wheelchair. Refer to
INSTALLING/REMOVING THE T-ARMS in this
procedure of the owners manual.
2. Remove the two (2) bottom socket screws that
secure the side guard to the bottom clamp.
3. Perform one (1) of the following:
Small Side Guards - Move the bottom clamp up
one (1) of two (2) mounting
positions in the side guard.
Large Side Guards - Move the bottom clamp up
one (1) of three (3) mounting
positions in the side guard.
4. Re-secure the side guard to the bottom clamp with
the two (2) socket screws.
5. Install the T-arm onto the wheelchair. Refer to IN-
STALLING/REMOVING THE T-ARMS in this pro-
cedure of the owners manual.
Socket
Screws
Bottom Clamp
Transfer
Assist
Side
Guard
T-arm
FIGURE 9 - ADJUSTING THE TRANSFER ASSISTS
AND/OR SIDE GUARDS - T-ARMS