Filter
Top Products
20
Removing/Replacing Armrests
1. Unlock the armrest assembly by flipping the arm
assembly release lever located on the side rail to
the UP (HORIZONTAL) position.
2. Remove the armrest assembly.
3. Install/reinstall new or existing armrest assembly.
NOTE: Armrest locks MUST be in the unlocked
position when placing arm into the arm sockets.
4. When installed, lock the armrest assembly by
pressing the release lever into the DOWN (VER-
TICAL) position.
REPLACING DESK/FULL LENGTH
ARMREST PAD (FIGURE 2)
1. Remove the phillips screws that secure the arm-
rest pad to the armrest assembly.
2. Replace armrest pad and securely tighten to the
armrest assembly with existing phillips screws.
WARNING
After ANY adjustments, repair or service and
BEFORE use, make sure all attaching hardware
is tightened securely - otherwise injury or dam-
age may result.
ADJUSTING/REMOVING/REPLACING
ARMREST ASSEMBLY (FIGURE 1)
WARNING
Make sure the locking mechanism is secured
before using the wheelchair.
Adjusting Armrest Height
1. Unlock the armrest assembly by flipping the armrest
release lever on the top front of the arm to the UP
(HORIZONTAL) position.
2. Adjust armrest assembly to desired height.
3. Lock the armrest assembly by pressing the release
lever into the DOWN (VERTICAL) position.
Locked
Unlocked
Armrest Release Lever
Armrest
Assembly
Locks Armrest Assembly
Adjusts
Armrest
Height
Armrest
Assembly
Phillips Screws
This Procedure includes the following:
Adjusting/Removing/Replacing Armrest
Assembly
Replacing Desk/Full Length Armrest Pad
Installing the T-Arm Sockets
Installing/Removing the T-Arms
Adjusting the T-Arms
Adjusting the Transfer Assists and/or Side
Guards - T-Arms
Replacing the Locking Lever - T-Arms
FIGURE 1 - ADJUSTING/REMOVING/
REPLACING ARMREST ASSEMBLY
Armrest
Pad
FIGURE 2 - REPLACING DESK/FULL LENGTH
ARMREST PAD
A
R
M
S
PROCEDURE 2 ARMS
INSTALLING THE T-ARM SOCKETS
(FIGURE 3)
1. Remove the rear wheels from the wheelchair. If
necessary, refer to the owner's manual supplied
with the wheelchair.
2. Position the T-arm clamp on the wheelchair frame
as shown in FIGURE 3.
NOTE: The T-arm socket must be positioned on
the outside of the wheelchair frame.
3. Install the hex bolts through the T-arm clamp,
wheelchair frame and coved washers and tighten
securely with locknuts.
4. Position the T-arm socket inserts in the T-arm
socket as shown in FIGURE 3.