Filter
Top Products
3 - 30
3.4 Buffer Memory
3.4.1 Buffer memory assignment
3
SPECIFICATIONS
3.4 Buffer Memory
3.4.1 Buffer memory assignment
This section describes the assignment of the Q68TD-G-H02 (H01) buffer memory.
POINT
Do not write data from system area or sequence program to the buffer memory area
where writing is disabled.
Doing so may cause malfunction.
Table 3.9 Buffer memory assignment
Addresses
Description Default value
Read/Write
*1
Reference
section
Hex. Dec.
00H 0 Conversion enable/disable setting 00FFH
R/W
*2
Section 3.4.2
01H 1 CH1 Time/Count/Moving average/Time constant setting 0
R/W
*2
Section 3.4.3
02H 2 CH2 Time/Count/Moving average/Time constant setting 0
R/W
*2
03H 3 CH3 Time/Count/Moving average/Time constant setting 0
R/W
*2
04H 4 CH4 Time/Count/Moving average/Time constant setting 0
R/W
*2
05H 5 CH5 Time/Count/Moving average/Time constant setting 0
R/W
*2
06H 6 CH6 Time/Count/Moving average/Time constant setting 0
R/W
*2
07H 7 CH7 Time/Count/Moving average/Time constant setting 0
R/W
*2
08H 8 CH8 Time/Count/Moving average/Time constant setting 0
R/W
*2
09H 9 System area - - -
0AH 10 Conversion completion flag 0 R Section 3.4.4
0BH 11 CH1 Measured temperature value 0 R
Section 3.4.5
0CH 12 CH2 Measured temperature value 0 R
0DH 13 CH3 Measured temperature value 0 R
0EH 14 CH4 Measured temperature value 0 R
0FH 15 CH5 Measured temperature value 0 R
10H 16 CH6 Measured temperature value 0 R
11H 17 CH7 Measured temperature value 0 R
12H 18 CH8 Measured temperature value 0 R
13H 19 Error code 0 R Section 3.4.6
14H 20 Setting range 1(Thermocouple type CH1-CH4) 0 R
Section 3.4.7
15H 21 Setting range 2(Thermocouple type CH5-CH8) 0 R
16H 22 Setting range 3(Offset/gain setting CH1-CH8) 0 R Section 3.4.8
17H 23 System area - - -
18H 24 Averaging processing selection (CH1-CH4) 0
R/W
*2
Section 3.4.9
19H 25 Averaging processing selection (CH5-CH8) 0
R/W
*2
1AH 26 Offset/gain setting mode(Offset specification) 0
R/W
*2
Section 3.4.10
1BH 27 Offset/gain setting mode(Gain specification) 0
R/W
*2