Filter
Top Products
6
PROGRAMMING
6.3 Using Programs on Remote I/O Network
6.3.3 Program example when GX Configurator-TI is not used
6 - 24
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
SETUP AND
PROCEDURES BEFORE
OPERATION
5
UTILITY PACKAGE (GX
CONFIGURATOR-TI)
6
PROGRAMMING
7
ONLINE MODULE
CHANGE
8
TROUBLESHOOTING
* 2 Un\G24: Averaging processing selection (CH1 to CH4) (Refer to Section 3.4.9)
Figure 6.24 Averaging processing selection (CH1 to CH4)
* 3 Un\G46: Warning output enable/disable setting (Refer to Section 3.4.13)
Figure 6.25 Warning output enable/disable setting
* 4 D1024 and D1046 are used for writing the initial setting data. (D2024 and D2046 are used for
reading the initial setting data.)
(3) GX Developer operation (Network parameter setting)
Figure 6.26 Network range assignment setting screen
• Refresh parameters:
Figure 6.27 Refresh parameters setting screen
• Network type : MNET/H (Remote master)
• Starting I/O No. : 0000
H
• Network No. : 1
• Total stations : 1
• Mode : Online
• Network range assignment :
H
0420
0H (Sampling processing)
2
H (Count average)
4
H (Primary delay filter)
CH4 CH3 CH2 CH1
H
FBFD
10111111
Rate alarm setting
b7 b6 b5 b4 b3 b2 b1 b0
CH8CH7CH6CH5 CH4CH3CH2CH1
CH3: 0 (Enable)
CH1, CH2, CH4 to CH8: 1 (Disable)
11011111
Process alarm setting
b7 b6 b5 b4 b3 b2 b1 b0
CH8CH7CH6CH5 CH4CH3CH2CH1
CH2: 0 (Enable)
CH1, CH3 to CH8: 1 (Disable)