Filter
Top Products
6
PROGRAMMING
6.2 Using Programs in Normal System Configuration
6.2.3 Program example when GX Configurator-TI is not used
6 - 14
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
SETUP AND
PROCEDURES BEFORE
OPERATION
5
UTILITY PACKAGE (GX
CONFIGURATOR-TI)
6
PROGRAMMING
7
ONLINE MODULE
CHANGE
8
TROUBLESHOOTING
(3) Program example
Figure 6.16 Program example for GX Configurator-TI is not used
Conversion enable/disable
setting
Turns ON Module
ready check flag.
Turns OFF Module
ready check flag.
Averaging processing
selection
Warning output
enable/disable setting
Initial setting of CH2
process alarm
Initial setting of CH3
rate alarm
Turns ON Operating
condition setting request (Y9).
Turns OFF Operating
condition setting request (Y9).
Reads measured
temperature values of
CH1 to CH3.
Resets Disconnection
detection signal (XC).
Processing at CH1
disconnection detection
Processing when CH2
process alarm has occurred
Processing when CH3
rate alarm has occurred