Filter
Top Products
5
UTILITY PACKAGE (GX Configurator-TI)
5.3 Utility Package Operation
5.3.3 Starting the Intelligent function module utility
5 - 12
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
SETUP AND
PROCEDURES BEFORE
OPERATION
5
UTILITY PACKAGE (GX
CONFIGURATOR-TI)
6
PROGRAMMING
7
ONLINE MODULE
CHANGE
8
TROUBLESHOOTING
(3) Menu bar
(a) File menu
Intelligent function module parameters of the project opened by GX Developer are
handled.
(b) Online menu
POINT
(1) Saving intelligent function module parameters in a file
Since intelligent function module parameters cannot be saved in a file by the
project saving operation of GX Developer, save them on the shown module
selection screen for intelligent function module parameter setting.
(2) Reading/writing intelligent function module parameters from/to a
programmable controller using GX Developer
• Intelligent function module parameters can be read from and written into
a programmable controller after having been saved in a file.
• Set a target programmable controller CPU in GX Developer: [Online]
[Transfer setup].
• When the Q68TD-G-H02(H01) is installed to the remote I/O station, use
"Read from PLC" and "Write to PLC".
(3) Checking the required utility
While the start I/O is displayed on the Intelligent function module utility setting
screen, "* " may be displayed for the model name.
This means that the required utility has not been installed or the utility cannot
be started from GX Developer.
Check the required utility, selecting [Tools] - [Intelligent function unit utility] -
[Utility list...] in GX Developer.
Figure 5.7 File menu
[Open parameters]
:
Reads a parameter file.
[Close parameters]
:
Closes the parameter file. If any data are modified, a
dialog asking for file saving will appear.
[Save parameters]
:
Saves the parameter file.
[Delete parameters]
:
Deletes the parameter file.
[Exit]
:
Closes this screen.
Figure 5.8 Online menu
[Monitor/Test] : Activates the Select monitor/test module screen.
[Read from PLC] : Reads the intelligent function module parameters from
the CPU module.
[Write to PLC] : Writes the intelligent function module parameters to the
CPU module.