Filter
Top Products
5 - 21
5.6 Monitoring/Test
5.6.2 Offset/gain setting operation
5
UTILITY PACKAGE (GX Configurator-TI)
5.6.2 Offset/gain setting operation
Perform the offset/gain setting operation in the following sequence.
(1) Display the "CH Offset/gain setting" screen
Display the "CH Offset/gain setting" screen of the channel where offset/gain
setting will be made using the operation described in Section 5.6.1.
(2) Switch to the offset/gain setting mode
Note) Do not perform this operation when the setting has been changed
to the offset/gain setting mode.
Set "Offset/gain setting mode" in the Setting value field for "Mode Switching Setting
"and click the button. The indication in the Current value field of "Mode
Switching Setting Status" changes to "Offset/gain setting mode".
(3) Enable the Conversion enable/disable setting
(a) Set "Enable" in the Setting value field for "Conversion enable/disable setting" and
click the button.
(b) Set "Request" in the Setting value field for "Operating condition setting request"
setting and click the button. The indication in the Current value field
changes from "OFF" to "Request".
(c) Set "OFF" in the Setting value field for "Operating condition setting request"
setting and click the button. The indication in the Current value field
changes from "Request" to "OFF".
(4) Adjustment of the offset and gain values
(a) Adjust the offset setting value
1) Select the offset setting
Select "Offset setting" in the Setting value field for "CH Offset setting channel
setting" and click the button.
2) Set the offset value
Enter the desired value into the Setting value field for "CH Offset
temperature setting value", and click the button.
3) Determine the offset value
Select "Request" in the Setting value field for "CH Channel change request"
setting and click the button.
Confirm that "CH Channel change completion flag" has changed to
"Completed", and then select "OFF" in the Setting value field of "CH Channel
change request" and click the button.
Select "Invalid" in the Setting value field for "CH Offset setting channel
setting" and click the button.