Filter
Top Products
7 - 6
7.3 Online Module Change Procedure
7.3.1 When factory default is used and initial setting was made with GX Configurator-TI
7
ONLINE MODULE CHANGE
(c) After confirming that the "RUN" LED of the module has turned off, remove the
external wiring and dismount the module.
POINT
Always dismount the module. If you execute mounting confirmation without
dismounting the module, the module will not start properly and the "RUN" LED will
not be lit.
(3) Mounting of new module
(a) Mount a new module to the same slot and install the external wiring.
(b) After mounting the module, click the button and make sure that the
"RUN" LED is lit. Module ready (X0) remains OFF.
Figure 7.5 "Online module change"screen
(4) Operation check
(a) To make an operation check, click the button to cancel control
resumption.
Figure 7.6 Cancel of control resumption