Filter
Top Products
Questions? Refer to Page 10-13 For Customer Care Information.
8-7
Review/Change Setup for Test Setup
The Review/Change Setup menus enable the operator to review/change
the test settings.
Under the Test Setup Menu, the following options can be viewed or
changed:
• All Tests
• Patient Test
• Control Test
• Security
• Test Type
In the All Tests menu, the following options can be viewed or changed:
• Upload Interval for sending stored data to other systems.
• Establish Operator ID requirements and barcode format.
In the Patient Test menu, the following options can be viewed or
changed:
• Establish Patient ID requirements and barcode format.
• Set the requirement for out-of-range and/or in-range comment codes.
• Management of memory full overwrite.
In the Control Test menu, the following options can be viewed or
changed:
• Enable high, normal and/or low control testing.
• Control test results presented as numeric or Pass/Fail.
• Set the requirement for in-range and/or out-of-range comment codes.
• Management of memory full overwrite.
In the Security menu, the following options can be viewed or changed:
• Set QC interval requirements.
• Set requirements to prevent testing by non-certified operators.
• Set requirements to prevent testing using test strip lots that have not
been qualified for use.
In the Test Type menu, the following options can be viewed or
changed:
• Set units of measurement.
• Set sample type prompts.
• Set action ranges. The action range can also be changed in
QC Manager. Refer to the QC Manager Operator’s Manual for more
information. Note: Default action range is 20-600.