Filter
Top Products
Questions? Refer to Page 10-13 For Customer Care Information.
8-5
What You See
on the Display
What You Do Comments
Change Setup:
If the monitor displays a message not indicated in these procedures,
please refer to section 10, Troubleshooting.
Use these steps to access the Change Setup menu:
1. Press On/Off to turn on
the monitor.
The Abbott logo screen
will appear for a few
seconds followed by the
product name, the
software version screen
and then the Test Mode
menu.
3. Press 5 for Change
Setup.
The display prompts the
operator to enter a
password of up to 8
characters. The password
is displayed as asterisks
on the monitor.
4. Key in the password,
then press Enter. If the
password is entered
incorrectly, the monitor
displays error message:
“Incorrect Password.”
Press Clear twice,
verify the password
then re-enter the correct
password and press
Enter.
The factory set password
is 123. Once in the
Change Setup Mode, it
is suggested that the
administrator change
the password. This can
be done in the System
Setup/Set Password
option.
2. Press Menu. The Menu Mode menu
will appear.