Filter
Top Products
2-6
Place the object to be scanned on a flat surface, by itself. This will
prevent other items from being accidentally scanned.
Press and hold down the Scan button to start the barcode scanner. A
visible red beam will be emitted from the monitor. Slowly move this
beam over the barcode on the item to be scanned. When the monitor
accepts the barcode, it will beep in acknowledgement. Without
releasing the Scan button, look down at the monitor. The operator
can view the data that was scanned by the monitor. Release the Scan
button to stop the scan and continue with the next step.
CAUTION: Never look into the barcode scanner beam or point it
toward anyone’s eyes. The beam could cause permanent
damage to the eye.
Class II and IIa Laser Product: Avoid Long Term Viewing of Direct
Laser Light.
Data Port
The Data Port is located at the bottom of the monitor. This port enables
the monitor to automatically transfer the data through a cable connector
to a PC, laptop, Laboratory Information System (LIS), or Hospital
Information System (HIS).
Battery Compartment
The monitor holds two AA alkaline batteries to power the monitor.
A rechargeable battery pack is also available from MediSense. The
rechargeable battery pack can recharge itself while the monitor is in the
optional docking station. To prolong the battery life of the monitor, the
monitor should be turned off when not in use. If the monitor is left on
and has not been used for 4 minutes, it will automatically shut itself off.