Filter
Top Products
Questions? Refer to Page 10-13 For Customer Care Information.
9-1
Once the test results have been collected during a prescribed period
of time, they will then be uploaded into the MediSense QC Manager
Data Management System. The QC Manager Data Management
System provides a simple and automated way to collect, report and
transfer data to a personal computer (PC).
Data upload is initiated by the computer and requires no special steps
by the operator, as long as the monitor is connected properly and the
QC Manager Program is running. For the data upload to begin, either
the monitor must be in the optional docking station or the
communications cable must be plugged into the data port on the
monitor. Once the connection is established, communication between
the monitor and the PC will begin automatically.
The monitor can send and receive data. During data upload, the monitor
cannot be used for testing. When this occurs, the monitor will display
the following message, “Please Wait for Data Upload”. Testing is
preempted while the monitor is sending or receiving data.
The technical details of the data upload are described in the QC
Manager manual. Data is transferred in ASTM E-1381 format.
If the monitor is removed before data transmission is complete, no
data will have been uploaded. The data will be uploaded as part of
the next data transmission.
If a problem occurs with the data upload, an error message may appear
on the monitor. Error messages are shown in the Troubleshooting
section of this manual. Further troubleshooting information for any
data upload question is provided in the QC Manager manual.
Error Messages:
Data Upload 9