Filter
Top Products
Data Review for Control History by Operator ID:
Please refer to page 5-2 of the Data Review section for the step-by-step
instructions to access the Data Review menu.
Note: If no tests are stored for the desired category that was
selected, the following message will be displayed on the monitor:
“No Stored Tests”.
Note: If no tests match the criteria specified, this message will be
displayed on the monitor: “No Tests Match Request”.
If the monitor displays a message not indicated in these procedures,
please refer to section 10, Troubleshooting.
Questions? Refer to Page 10-13 For Customer Care Information.
5-17
What You See
on the Display
What You Do Comments
1. Press 2 – Control
History.
The Control Test History
menu now appears.
2. Press 2 – Operator ID. The monitor will prompt
for the Operator ID to be
scanned or entered.
3. Scan or manually enter
the Operator ID via the
keypad, then press
Enter.
The monitor will display
the Operator's most recent
control test result.