Filter
Top Products
This field specifies the minimum length that the barcode data (not including Code ID) must meet to be processed.
Any barcode scanned that is less than the number of characters specified in the Min field is rejected. The default for this field is
1.
Max
This field specifies the maximum length that the barcode data (not including Code ID) can be processed. Any barcode scanned
that has more characters than specified in the Max field is rejected. The default for this field is All (9999).
If the value entered is greater than the maximum value allowed for that symbology, the maximum valid length is used instead.
Strip Leading/Trailing Control
This group of controls determines what data is removed from the barcode before the data is buffered for the application. When
all values are set, Code ID takes precedence over Leading and Trailing; Barcode Data stripping is performed last. Stripping
occurs before the Prefix and Suffix are added, so does not affect them.
If the total number of characters being stripped is greater than the number of characters in the barcode data, it becomes a zero
byte data string. If, in addition, Strip Code ID is enabled, and no prefix or suffix is configured, the processing will return a zero-
byte data packet, which will be rejected.
The operation of each type of stripping is defined below:
Leading
This strips the number of characters specified from the beginning of the barcode data (not including Code ID). The data is
stripped unconditionally. This action is disabled by default.
Trailing
This strips the number of characters specified from the end of the barcode data (not including Code ID). The data is stripped
unconditionally. This action is disabled by default.
Code ID
Strips the Code ID based on the type code id specified in the Enable Code ID field in the Barcode tab. By default, Code ID
stripping is enabled for all symbologies (meaning code IDs will be stripped, unless specifically configured otherwise).
Barcode Data Match List
Barcode Data Panel
This panel is used to strip data that matches the entry in the Match list from the barcode. Enter the data to be stripped in the
text box and tap the Insert or Add button. The entry is added to the Match list.
To remove an entry from the Match list, highlight the entry in the list and tap the Remove button.
Tap the OK button to store any additions, deletions or changes.
3-139