Filter
Top Products
Enable RFTerm Auto Launch
This option is enabled by default. This option, when disabled (unchecked) stops RFTerm from launching at bootup. When
RFTerm is not installed or has not been added to the registry Launch sequence, this checkbox is ignored at bootup.
Enable Auto Launch IP Wait
When enabled, this feature works as follows:
1. After the radio .CAB file is unpacked, the Launch program waits for the radio driver to load and for the radio to connect
and obtain an IP address.
2. During the wait, a message window is displayed containing the NDIS communication messages up to and including the
display of the valid IP address.
3. After the IP address is obtained, the message window is displayed for one second and then removed.
4. Launch completes its normal task path, unpacking any remaining .CAB files and completing any remaining tasks.
5. If an IPaddress is not obtained within the specified timeout period (see below), Launch completes its normal task path.
The default is unchecked (disabled). Launch does not wait for an IP address.
IP Wait Timeout
This parameter specifies the maximum time period Launch waits for a valid IP address before completing any remaining tasks.
The timeout can be from 1 to 60 seconds. The default is 30 seconds.
3-106