Filter
Top Products
User Access Panel
The User Access Panel cover can be removed to access the storage slots available on the VX7. The available slots and any
factory installed cards in those slots depend upon the system configuration ordered.
Remove User Access Panel Cover
1. Turn the VX7 off and detach the power cable.
2. Loosen the three (3) Phillips head screws securing the access panel cover so the cover can be removed. The screws
are a captive part of the cover and cannot be removed.
3. Move the tethered cover aside to access the card slots. Use care not to unplug or damage the antenna leads. If the VX7
has an internal antenna, it is secured to the inside of the cover.
Although some cards can be hot swapped, the VX7 is not environmentally sealed while the access panel cover is
removed to hot swap cards. Honeywell recommends powering off the VX7 and disconnecting the power cable
before removing the user access panel.
Inside the User Access Panel
1. SD Card Slot
2. CF Card Slot (if
present)
3. PCMCIA Slot B
4. PCMCIA Slot A
l If a CF card slot is present, the CF card contains the system files. The CF card must be present to boot the VX7.
l If a CF card slot is not present, the SD card contains the system files. The SD card must be present to boot the VX7.
l The 802.11 radio card is installed by the factory in PCMCIA Slot A. This card must remain in this slot to avoid damage
to the antenna cables.
User provided storage cards can be installed in:
l SD card slot only if a CF card slot is present
l PCMCIA slot B, accepts Type I or II PCMCIA cards
Install or remove storage cards as desired.
2-31