Filter
Top Products
20
Reference Manual
00809-0100-4102, Rev AA
Section 2: Configuration
May 2013
Configuration
2.7 Review configuration data
The following is a list of factory default configurations that can be viewed by using the Field
Communicator or AMS. Follow the steps below to review the transmitter configuration
information.
Note
Information and procedures in this section that make use of Field Communicator fast key
sequences and AMS assume that the transmitter and communication equipment are
connected, powered, and operating correctly.
2.7.1 Review pressure information
To view pressure information:
1. From the Home screen, select 2: Configure.
2. Select 2: Manual Setup.
3. Select 2: Pressure.
4. Select from the corresponding number to view each field:
2.7.2 Review device information
To view device information:
1. From the Home screen, select 2: Configure.
2. Select 2: Manual Setup.
3. Select 9: Device Information.
4. Select from the corresponding number to view each field:
Fast Keys
2, 2, 2
1 Pressure
2 Pressure Status
3 Units
4 Damping
Fast Keys
2, 2, 9
1 Identification
2 Revisions
3 Radio
4 Sensor Information
5 Flange Information
6 Remote Seal