Filter
Top Products
127
Reference Manual
00809-0100-4102, Rev AA
Appendix A: Reference Data
May 2013
Specifications and Reference Data
A.7 Options
Standard configuration
Unless otherwise specified, transmitter is shipped as follows:
Custom configuration
If Option Code C1 is ordered, the customer may have the factory pre-configure special
parameters in the transmitter.
Refer to the “Rosemount 2051 Wireless Configuration Data Sheet” document number
00806-0100-4102.
Tagging (3 options available)
Standard SST hardware tag is wired to the transmitter. Tag character height is 0.125 in.
(3,18 mm), 56 characters maximum.
Tag may be permanently stamped on transmitter nameplate upon request, 56
characters maximum.
Tag may be stored in transmitter memory. Character limit is dependent on protocol.
–- WirelessHART: 32 characters
Optional Rosemount 304, 305, or 306 Integral Manifolds
Factory assembled to 2051C and 2051T transmitters. Refer to the following Product Data Sheet
(document number 00813-0100-4839 for Rosemount 304 and 00813-0100-4733 for
Rosemount 305 and 306) for additional information.
Other seals
Refer to Product Data Sheet 00813-0100-4016 for additional information.
Engineering units
Differential/Gage:
inH
2
O (Range 0, 1, 2, and 3)
psi (Range 4 and 5)
Absolute/2051TA:
psi (all ranges)
Low Limit:
0 (engineering units above)
High Limit:
Upper range limit
Output:
Linear
Flange type:
Specified model code option
Flange material:
Specified model code option
O-ring material:
Specified model code option
Drain/vent:
Specified model code option
LCD Display:
Installed or none
Software tag:
(Blank)