Filter
Top Products
3-42
BATTERY INSPECTION/FUSE INSPECTION
INSP
ADJ
NOTE:
CAUTION:
CAUTION:
*****************************************************
*****************************************************
NOTE:
6. Inspect:
D Battery terminals
Dirty terminal ! Clean with wire brush.
Poor connection ! Correct.
After cleaning the terminals, grease them light-
ly.
7. Install:
D Battery
8. Connect:
D Battery leads
Connect the positive lead first and then connect
the negative lead.
9. Install:
D Cover (battery case)
D Mat (right)
Refer to “COVER AND PANEL” section.
YP305010
FUSE INSPECTION
Always turn off the main switch when checking
or replacing the fuse. Otherwise, a short circuit
may occur.
1. Remove:
D Mat (right)
D Cover (battery case)
Refer to “COVER AND PANEL” section.
2. Inspect:
D Fuse
Inspection steps:
D Connect the Pocket tester to the fuse and
check it for continuity.
Set the tester selector to “Ω 1” position.
Pocket tester:
90890-03112
D If the tester is indicated at ∞. Replace the
fuse.