Filter
Top Products
3-17
ENGINE OIL REPLACEMENT/
ENGINE OIL PRESSURE INSPECTION
INSP
ADJ
*************************************
*****************************************************
NOTE:
*****************************************************
5. Fill:
D Crankcase
Oil quantity:
1.4L
6. Check:
D Engine oil level
Refer to “ENGINE OIL LEVEL INSPEC-
TION” section.
7. Reset:
D Engine oil warning circuit
Resetting steps:
D Turn the main switch to on.
D Push and hold in the reset button for 2 to 5
seconds.
D Release the reset button
1
and the oil in-
dicator light will go off.
If the oil is changed before the oil indicator light
comes on (i.e. before the 3,000 km oil change
interval is reached), be sure to reset the oil indi-
cator light after changing the oil, so that it will
come on at the correct time to indicate the next
3,000 km oil replacement.
To reset the oil indicator light before it comes on:
Release the reset button and the oil indicator
light will come on for 1.4 seconds.
YP*****
ENGINE OIL PRESSURE INSPECTION
1. Remove:
D Side panels
Refer to the “COVER AND PANEL” sec-
tion.
2. Inspect:
D Oil pressure
Inspection steps:
D Slightly loosen the oil check bolt
1
.
D Start the engine and keep it idling until the oil
begins to seep from the oil check bolt.
If no oil comes out after one minute, turn the
engine off so it will not seize.
D Check oil passages and oil pump for damage
or leakage.