Filter
Top Products
3-22
COOLANT REPLACEMENT
INSP
ADJ
NOTE:
YP303180
COOLANT REPLACEMENT
1. Remove:
D Side panels
D Fuel tank
Refer to the “COVERS AND PANEL”
section.
2. Remove:
D Hose
1
(reservoir tank)
Drain the reservoir tank of its coolant.
3. Remove:
D Drain bolt
1
D Radiator cap
Open the front trunk, remove the cover,
slowly loosen to remove the radiator cap
and drain the coolant.
Do not remove the radiator cap when the en-
gine and radiator are hot. Scalding hot fluid
and steam may be blown out under pres-
sure, which could cause serious injury.
When the engine has cooled, open the radia-
tor cap as follows:
Place a thick rag or a towel over the radiator
cap. Slowly rotate the cap counterclockwise
toward the detent. This allows any residual
pressure to escape. When the hissing sound
has stopped, press down on the cap while
turning counterclockwise and remove it.
D Remove the radiator cap after removing the
drain bolt.
D Place the scooter upright on a level surface
when draining the coolant completely.
4. Clean:
D Radiator
Fill soft water into the filler neck support
1
(reservoir tank).