Filter
Top Products
3-32
STEERING HEAD INSPECTION/
FRONT FORK INSPECTION
INSP
ADJ
NOTE:
75 Nm (7.5 mSkg)
*****************************************************
D Install the lock washer
1
.
Make sure the lock washer tabs sit correctly in
the ring nut slots.
D Hold the ring nut (under and center), using
the exhaust and ring nut wrench, and tighten
the ring nut (upper) using the ring nut wrench.
Exhaust and ring nut wrench:
90890-01268
8. Install:
D Woodruff key
D Handlebar lower holder
Refer to “STEERING” section in CHAP-
TER 7.
D Handlebar
Refer to “HANDLEBER” section in
CHAPTER 7.
9. Install:
D Handlebar cover
Refer to “COVER AND PANEL” section.
YP304140
FRONT FORK INSPECTION
Securely support the scooter so that there is no
danger of it falling over.
1. Stand the scooter on a level surface.
2. Check:
D Inner tube
Scratches/damage ! Replace.
D Oil seal
Excessive oil leakage ! Replace.
Hold the scooter upright and apply the
front brake.
3. Check:
D Operation
Push down hard on the handlebars sev-
eral times.
Unsmooth operation ! Repair.
Refer to “FRONT FORK” in CHAPTER 7.