Filter
Top Products
1-6
IMPORTANT INFORMATION
GEN
INFO
NOTE:
NOTE:
EB801000
CHECKING OF CONNECTIONS
Dealing with stains, rust, moisture, etc. on the
connector.
1. Disconnect:
SConnector
2. Dry each terminal with an air blower.
3. Connect and disconnect the connector two
or three.
4. Pull the lead to check that it will not come
off.
5. If the terminal comes off, bend up the pin
1
and reinsert the terminal into the connector.
6. Connect:
SConnector
The two connectors “click” together.
7. Check for continuity with a tester.
D If there is no continuity, clean the terminals.
D Be sure to perform the steps 1 to 7 listed
above when checking the wireharness.
D For a field remedy, use a contact revitalizer
available on the market.
D Use the tester on the connector as shown.