Filter
Top Products
2-13
MAINTENANCE SPECIFICATIONS
SPEC
NOTE:
1. First, tighten the ring nut (lower) approximately 38 Nm (3.8 mSkg) by using the torque wrench, then
loosen the ring nut 1/4 turn.
2. Second, tighten the ring nut (lower) approximately 22 Nm (2.2 mSkg) by using the torque wrench,
then finger tighten the ring nut (center). Align the slots both ring nut and install the lock washer.
3. Final, hold the ring nuts (lower and center) and tighten the ring nut (upper) 75 Nm (7.5 mSkg) by
using the torque wrench.