Filter
Top Products
3-30
REAR BRAKE ADJUSTMENT/
BRAKE SHOE INSPECTION/STEERING HEAD INSPECTION
INSP
ADJ
CAUTION:
*****************************************************
NOTE:
D Tighten the locknut (s).
Rear wheel side:
D Turn the adjuster
3
in or out until the speci-
fied free play is obtained.
Turning in ! Free play is decreased.
Turning out ! Free play is increased.
Make sure that the brake does not drag after
adjusting it.
YP304040
BRAKE SHOE INSPECTION
1. Operate the brake lever.
2. Inspect:
D Brake shoes
Wear indicator
1
reaches the wear limit
line
2
! Replace the brake shoes as a
set.
Refer to “REAR WHEEL” in CHAPTER
6.
YP304130
STEERING HEAD INSPECTION
Securely support the scooter so that there is no
danger of it falling over.
1. Stand the scooter on a level surface.
Stand the scooter on its centerstand.
2. Elevate the front wheel by placing a suit-
able stand under the engine.
3. Check:
D Steering assembly bearings
Grasp the bottom of the lower front fork
tubes and gently rock the fork assembly.
Looseness ! Adjust the steering head.
4. Remove:
D Handlebar cover
Refer to “COVER AND PANEL” section.
D Handlebar
Refer to “HANDLEBAR” section in chap-
ter 7.