Filter
Top Products
3-16
ENGINE OIL LEVEL INSPECTION/
ENGINE OIL REPLACEMENT
INSP
ADJ
CAUTION:
NOTE:
32 Nm (3.2 mSkg)
NOTE:
RECOMMENDED ENGINE OIL
Refer to the chart for selection of the oils suited
to the atomosperic temperature.
API STANDARD:
API SE or higher grade
D Do not put in any chemical sdditives or
use oils with a grade of CD
a
or higher.
D Be sure not to use oils labeled “ENERGY
CONSERVING II”
b
or higher. Engine oil
also lubricates the clutch and additives
could cause clutch slippage.
D Be sure no foreign material enters the
crankcase.
5. Start the engine and let it warm up for a few
minutes.
6. Turn off the engine.
Wait a few minutes until the oil settles before in-
specting the oil level.
YP*****
ENGINE OIL REPLACEMENT
1. Start the engine and let it warm up for sev-
eral minutes.
2. Turn off the engine and place an oil pan un-
der the engine.
3. Remove:
D Oil filler plug
D Drain plug
1
D Compression spring
2
D Oil strainer
3
D O-ring
Drain the crankcase of its oil.
4. Install:
D O-ring
1
D Compression spring
2
D Oil strainer
3
D Drain plug
4
D Oil filler plug
Check the O-ring (drain plug). If damaged, re-
place it with a new one.