Filter
Top Products
SECTION 10—SHROUDS AND FRAME
Part No. 1125075 95 Pronto® Series
Installing
1. Secure the actuator switch sensor to the elevate actuator using the two screws and
small washers. Tighten securely.
2. Secure the elevate actuator to the top of the frame using the four button screws and
washers. Torque to 75 in-lbs ± 20%.
3. Secure the elevate actuator to the bottom of the frame using the four hex screws and
washers. Torque to 75 in-lbs ± 20%.
4. Connect the actuator connector to the controller connector (Detail “A”).
5. Secure the cables to the frame using three tie-wraps in the locations shown in Detail
“A ” .
6. Install the batteries. Refer to Removing/Installing Batteries from/into Battery Tray on
page 99.
7. Install the seat. Refer to one of the following procedures:
• Van Seats - Refer to Removing/Installing the Seat Assembly on page 50.
• ASBA Seats - Refer to Removing/Installing the Seat Assembly on page 59.