Filter
Top Products
SECTION 3—SAFETY INSPECTION/TROUBLESHOOTING
Pronto® Series 20 Part No. 1125075
❑ Ensure seat is secured to wheelchair frame.
❑ Ensure seat release latch is not worn and is functional. Replace if necessary.
❑ Ensure arm pivot points are not worn and/or loose. Replace if necessary.
❑ Inspect for any loose hardware on the wheelchair.
❑ Inspect charger AC power cord for damage. Replace if necessary.
❑ Check that all labels are present and legible. Replace if necessary.
❑ Inspect electrical components for signs of corrosion. Replace if corroded or damaged.
Additional Requirements for M61 Wheelchairs
❑ Make sure elevate operates smoothly and properly.
❑ Make sure elevate systems drive with reduced speed when seat is in elevated position.
Troubleshooting
NOTE: For additional troubleshooting information and explanation of error codes, refer to the
individual electronics manual supplied with each wheelchair.
Wheels
About Joystick Diagnostics
The joystick information gauge and the service indicator give indications of the type of
fault or error detected by the control module. When a fault is detected, the wheelchair
may stop and not drive. The LEDs on the information gauge may flash in a particular
pattern or the service indicator light will flash. The number or type of flashes indicates the
nature of the error. If multiple errors are found, only the first error encountered by the
control module will be displayed.
WHEELCHAIR VEERS
LEFT/RIGHT
SLUGGISH TURN/
PERFORMANCE
CASTERS
FLUTTER
SQUEAKS AND
RATTLES
LOOSENESS
IN WHEELCHAIR
WHEELCHAIR 3
WHEELS
SOLUTIONS
X X X If pneumatic, check tires for correct and equal pressure.
X X X X Check for loose stem nuts/bolts.
X X Check that casters contact ground at the same time.