Filter
Top Products
SECTION 7—ASBA SEAT
Part No. 1125075 67 Pronto® Series
FIGURE 7.7 Removing/Installing the Seat Positioning Strap
Removing/Installing the Back Upholstery
NOTE: The back canes MUST be removed when removing/installing the back upholstery. Refer to
Removing/Installing/Changing the Back Cane Height on page 67.
Removing/Installing/Changing the Back Cane Height
NOTE: For this procedure, refer to FIGURE 7.8 on page 70.
NOTE: If changing the back height, new back upholstery may be needed as well. Refer to the
following chart to determine if new back upholstery is needed:
NOTE: Existing hardware and inserts will be reused.
NOTE: Take note of position and orientation of mounting hardware for reinstallation.
Removing
1. Remove flip back armrest from the wheelchair. Refer to Removing/Installing Flip Back
Armrest on page 47.
NOTE: Note the back angle before disassembly for proper reinstallation.
NOTE BACK UPHOLSTERY
HEIGHT
If back height required is within the range of the original back upholstery
height, only new back canes will be needed.
16 to 17 inches
18 to 19 Inches
If the back height required is NOT within the range of the original back uphol-
stery height, new back upholstery, and back canes will be required
20 inches
21 to 22 inches
Mounting
Screw
Seat Positioning Strap
Quick Release Pin Tab
Seat Rail
Locknut
Spacer
Seat Pan
Front of Seat
Frame
Rear of Seat
Frame