Filter
Top Products
SECTION 10—SHROUDS AND FRAME
Pronto® Series 92 Part No. 1125075
Installing
1. If necessary, insert one bushing into each end of the pivot tube.
2. Position the pivot tube onto the pivot post.
NOTE: Ensure the opposite end of the pivot tube is parallel to the end of the walking beam. If
necessary, reposition the pivot tube.
3. Secure the end of the pivot tube to the pivot post using the two small washers, the
large washer and the locknut. Torque to 90 in-lbs ± 20%.
4. Install the front headtube assembly. Refer to Removing/Installing the Front Headtube
Assembly on page 83.
FIGURE 10.5 Removing/Installing the Pivot Tube
Small Washers
Locknut
Large Washer
Bushings
Pivot Tube
Pivot Post
Walking Beam