Filter
Top Products
SECTION 8—FRONT RIGGINGS/FOOTBOARD
Pronto® Series 76 Part No. 1125075
Raising/Lowering Elevating Front Riggings
NOTE: For this procedure, refer to FIGURE 8.5.
1. Perform one of the following:
• Raising - Pull back on the release
lever and raise front rigging to the
desired height.
• Lowering - Support front rigging
with one hand away from the
release lever. Push release lever
downward with other hand.
FIGURE 8.5 Raising/Lowering Elevating
Front Riggings
Adjusting/Replacing Telescoping Front Rigging
Supports
Van Seats
NOTE: For this procedure, refer to FIGURE 8.6 on page 77.
NOTE: When adjusting the telescoping front rigging support depth, ensure the footplate does not
interfere with the caster wheel rotation.
NOTE: Telescoping front rigging supports may be extended up to 2-inches from the wheelchair
frame in 1-inch increments. This adjustment does not affect seat depth.
NOTE: When installing the front rigging support tubes, ensure that the hinge pins are on the
outside of the chair facing away from the seat frame.
1. Remove the seat assembly. Refer to Removing/Installing the Seat Assembly on
page 50.
2. Remove the two socket bolts, spacers and locknuts that secure telescoping front
rigging support to the seat frame.
3. Perform one of the following:
• Adjusting - Align the appropriate mounting hole of the telescoping front rigging
support with the front mounting hole in the seat frame tubes to achieve the desired
depth (FIGURE 8.6).
• Replacing - Perform the following:
i. Remove the existing telescoping front rigging support from the wheelchair
frame.
ii. Insert the new telescoping front rigging support into the seat frame.
iii. Align the appropriate mounting hole of the telescoping front rigging support
with the front mounting hole in the seat frame tubes to achieve the desired
depth (FIGURE 8.6).
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
Release
Lever