Filter
Top Products
SECTION 7—ASBA SEAT
Part No. 1125075 63 Pronto® Series
FIGURE 7.3 Adjusting the Seat Height - M61 Wheelchairs
Removing/Installing the Seat Pan
NOTE: For this procedure, refer to FIGURE 7.4 on page 64.
NOTE: Note of the position and orientation of the mounting hardware, seat positioning straps and
quick release pin tabs for installing of the seat pan.
NOTE: Reverse this procedure to install the seat pan. Torque locknuts to 75-inch-lbs.
1. Perform one of the following:
• Remove seating system. Refer to manufacturers seating system installation
instructions.
• Remove cushion by pulling up to release hook and loop strips. Remove cushion
from seat pan.
2. Remove the two rear mounting screws, quick release pin tabs, spacers and locknuts
that secure the seat pan and seat positioning straps to the seat frame.
NOTE: The two front mounting screws, spacers and locknuts also secure the front rigging support
tubes to the seat frame.
3. Remove the four mounting screws, locknuts and four spacers securing the seat pan to
the seat frame (FIGURE 7.4).
4. Remove the seat pan from the seat frame.
Seat Frame Plate
1-inch Adjustment
Spacers
1-inch Adjustment
Spacers
Seat Pivot
Mounting Screws
Washers
Locknuts
Seat Frame