Filter
Top Products
SECTION 7—ASBA SEAT
Pronto® Series 60 Part No. 1125075
FIGURE 7.1 Removing/Installing the Seat Assembly
Adjusting the Seat Height
M50/51 Wheelchairs Only
NOTE: For this procedure, refer to FIGURE 7.2 on page 61.
NOTE: The seat can be adjusted to five height positions in 1-inch increments.
1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 59.
2. Remove the mounting screw that secures the seat post to the support tube.
ƽ WARNING
Refer to the table in FIGURE 7.2 on page 61 for proper seat post mounting
positions. For users over 220 lbs - Mounting holes 3, 4 and 5 (in FIGURE 7.2) MUST
be used with the seat in the 1-inch back position (FIGURE 7.2). Refer to Adjusting
the Seat Position on page 65.
3. Adjust the seat post to desired mounting position.
Seat
Assembly
Seat Lever
Seat Post