Filter
Top Products
SECTION 10—SHROUDS AND FRAME
Part No. 1125075 91 Pronto® Series
FIGURE 10.4 Removing/Installing the Inner Shrouds
Removing/Installing the Pivot Tube
NOTE: For this procedure, refer to FIGURE 10.5 on page 92.
Removing
1. Remove the front headtube assembly. Refer to Removing/Installing the Front
Headtube Assembly on page 83.
2. Remove the side shroud. Refer to Removing/Installing the Side Shrouds
on page 88.
3. remove the locknut, two small washers and large washer securing the rear of the pivot
tube to the threaded post.
4. Remove the pivot tube from the frame.
NOTE: The front and rear bushings may fall out of the pivot tube when it is removed. Retain these
for installation.
Side
Shroud
Walking
Beam
Inner
Shroud
Large Screw
Small Screw
Large
Mounting
Hole
Small
Mounting
Hole