Filter
Top Products
SECTION 8—FRONT RIGGINGS/FOOTBOARD
Pronto® Series 80 Part No. 1125075
FIGURE 8.9 Adjusting the Footboard Assembly - Angle
Depth
NOTE: For this procedure, refer to FIGURE 8.10.
1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame.
ƽ WARNING
Make sure the detent balls of the quick-release pin are fully released and beyond the
outer edge of the tube before operating the wheelchair. Otherwise, injury and/or
damage may result.
Keep detent balls clean.
2. Adjust footboard to one of three mounting positions.
3. Install the quick release pin. Make sure the detent balls of the quick-release pin are
fully released and beyond the outer edge of the tube (Detail “A”).
FIGURE 8.10 Adjusting the Footboard Assembly - Depth
Set Screw, Washer
and Jam Nut
Footboard
Assembly
Bottom View of
Footboard
DETAIL “A” - BOTTOM VIEW OF
FOOTBOARD
Quick
Release Pin
Detent
Ball
Footboard
Assembly
Mounting
Hole
Top Shroud
Quick Release Pin
Outer Edge
of Tube
Detent Balls
Three Depth
Adjustment Holes