Filter
Top Products
SECTION 8—FRONT RIGGINGS/FOOTBOARD
Part No. 1125075 75 Pronto® Series
Model PH904A and PHAL4A Front Riggings
NOTE: For this procedure, refer to FIGURE 8.3.
1. Loosen, but DO NOT remove the lug
bolt and locknut that secure the lower
footrest to the footrest support.
2. Reposition the lower footrest to the
desired height.
3. Securely tighten the lug bolt and
locknut that secure the lower footrest to
the footrest support.
4. Repeat STEPS 1-3 for the opposite side
of the wheelchair footrest, if necessary.
FIGURE 8.3 Model PH904A and PHAL4A
Front Riggings
Replacing Heel Loops
NOTE: For this procedure, refer to FIGURE 8.4.
1. Note the position of hex bolt, coved washers and locknut for reinstallation.
2. Remove the hex bolt, coved washers and locknut that secure the lower footrest to the
footrest support.
3. Remove the lower footrest.
4. Remove the mounting screw, spacer
and locknut that secure the existing
heel loop to the lower footrest.
5. Slide the existing heel loop off the
lower footrest.
6. Replace heel loop.
7. Reverse STEPS 1-6 to reassemble.
NOTE: When securing heel loop to lower
footrest, tighten the mounting screw and
locknut until the spacer is secure.
FIGURE 8.4 Replacing Heel Loops
Footrest
Support
Lug Bolt
Locknut
Lower Footrest
NOTE: PH904A style front rigging shown.
PHAL4A front rigging adjust the same way.
Footrest Support
Hex Bolt
Mounting
Screw
Spacer
Heel
Loop
Locknut
Lower Footrest
Coved
Washer
Locknut