Filter
Top Products
SECTION 11—BATTERIES
Part No. 1125075 99 Pronto® Series
Using the Proper Batteries
NOTE: For this procedure, refer to FIGURE 11.1.
1. Place battery on ground/flat surface.
2. Visually draw a horizontal and vertical centerline through the middle of battery
(FIGURE 11.1).
3. Position the battery so that the terminals are above the horizontal centerline.
4. Visually inspect the battery to ensure the correct position of the POSITIVE and
NEGATIVE terminals (FIGURE 11.1).
ƽ WARNING
Batteries with terminal configuration as shown below MUST be used. Batteries that
have the reverse terminal configuration MUST NOT be used - otherwise injury and
damage may occur.
FIGURE 11.1 Using the Proper Batteries
Removing/Installing Batteries from/into Battery Tray
ƽ WARNING
ALWAYS use the battery handle when lifting the battery. It is the most convenient
method and assures that the battery acid will not spill. It also helps to prolong the
life of the battery.
DO NOT tip the batteries. Keep the batteries in an upright position.
DO NOT Use
POSITIVE (+)
Battery Terminal
U1 Battery
U1 Battery
POSITIVE (+)
Battery Terminal
NEGATIVE (-)
Battery Terminal
Use This Configuration
NEGATIVE (-)
Battery Terminal