Filter
Top Products
SECTION 4—WHEELCHAIR OPERATION
Pronto® Series 32 Part No. 1125075
SECTION 4—WHEELCHAIR
OPERATION
ƽ WARNING
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Set-up of the Electronic Control Unit is to be performed only by a qualified
technician. The final adjustments of the controller may affect other activities of the
wheelchair. Damage to the equipment could occur if improperly set-up or adjusted.
Turning the Power On/Off
M50 and M51 Wheelchairs Manufactured Before 8/15/05
NOTE: For this procedure, refer to FIGURE 4.1.
1. Turn the power On by moving the On/Off switch up or down. The switch
automatically retracts back to center position.
NOTE: After turning power On, all indicators
will light briefly and the display gauge will
indicate one of the following:
• The Current Battery Charge -
Information gauge shows all LEDs lit
or partial LEDs lit. Refer to table in
Information Gauge Display on page 40.
• Out Of Neutral At Power Up -
Information Gauge shows all LEDs
flashing slowly. This occurs when the
power is turned On when the joystick is
out of neutral. This feature prevents
sudden and unexpected movements of
the power chair.
2. Turning the power Off can be achieved
by moving the On/Off switch up or
down. The switch automatically
retracts back to center position.
FIGURE 4.1 Turning the Power On/Off -
M50 and M51 Wheelchairs Manufactured
Before 8/15/05
INVACARE
Information
Gauge
ON/OFF
Toggle Switch