Filter
Top Products
HIGHLIGHTS OF CHANGES (CONTINUED)
Effective May, 1998 Rev. 2.0 (Continued)
Page Summary
Page 6-4 Updated Figure 6-3 to include last calibration failed alarm.
Page 6-6 Added fault 14 to Table 6-1.
Page 6-14 Added NOTE to determine when to replace the diffusion element.
Page 7-1 Added general troubleshooting information to paragraph 7-1. Added 4-20
mA line output information to paragraph 7-3 and Table 7-1. Added fault
14 to Table 7-1.
Page 7-8 Modified the case temperature in paragraph 7-3.f.1.
Page 7-15 Added new paragraph 7-3.n and Figure 7-14 to explain a last calibration
failed indication and troubleshooting instructions.
Page 8-1 Updated European address.
Pages 10-1 through
10-4
Added Section 10, Optional Accessories.
Effective Oct., 1998 Rev. 2.1
Page Summary
Page P-3 through P-9 Added Material Safety Data Sheets.
Page 1-5 Changed source of instrument air from required to optional.
Page 2-9 Added CAUTION concerning uninsulated stacks and ambient
temperatures.
Page 2-10 Added paragraph 2-2.c.3 concerning alarm contacts without
autocalibration.
Page 2-11 Modified paragraph 2.3. Added paragraphs 2-3.a and b concerning
autocalibration and alarms contacts.
Page 3-5 Added paragraph 3-3 concerning recommended configurations. Subse-
quent paragraphs renumbered.
Page 6-10 through
6-11
Deleted references in paragraphs 6-5.b, c, and d to remove and install
oxymitter from stack. Procedures 6-5.b, c, and d renumbered.
Page 6-15 Added paragraph 6-9 Ceramic Diffusion Element Replacement. Subse-
quent paragraphs renumbered.
Page 7-1 Modified paragraph 7-2 to explain alarm indications will be available via
HART. Added paragraph 7-3 concerning alarm contacts and autocalibra-
tion. Subsequent paragraphs renumbered.
Page 7-3 Modified Table 7-1 Diagnostic/Unit Alarm Fault Definitions.
Page 9-1 Changed Figure and Index No., Part Numbers, and Descriptions.