Filter
Top Products
SECTION 25—SIEVE BED PRESSURE CHECK
Platinum™Series 98 Part No 1110538
7. If pressure in the concentrator does not fall into the specifications listed above, refer
to Troubleshooting on page 17.
8. Turn the concentrator off (O).
9. Unclamp the pressure gauge and remove it from the "T" fitting.
FIGURE 25.3 Pressure Testing
After Testing
NOTE: For this procedure, refer to FIGURE 25.4.
1. Insert ¼-inch plug and ¼ x 2-inch silicone tubing onto the "T" fitting and secure with
¼-inch clamp.
2. Reinstall the cabinet. Refer to Removing Cabinet on page 25.
FIGURE 25.4 After Testing
Pressure
Gauge
¼-inch Clamp
(STEP 1)
Product
Tank
Adjustable
Clamp
¼-inch Clamp
¼-inch Plug