Filter
Top Products
SECTION 13—CONTROL PANEL
Part No 1110538 63 Platinum™Series
11. Remove spade connectors from circuit breaker, hour meter and On/Off ( ) switch.
(Jumper wire harness from On/Off switch to circuit breaker does not have to be
removed).
12. Remove control panel and reverse STEPS 3-10 to re-install control panel.
13. Run unit and check for leaks at pressure sensor tubing on product tank cap. Refer to
Leak Test on page 89
14. Reinstall cabinet. Refer to Removing Cabinet on page 25.
FIGURE 13.1 Removing Control Panel
I/O
Circuit Breaker
(STEP 10)
Hour Meter
(STEP 10)
1/8” I.D. Pressure
Sensor Tubing (STEP 5)
Oxygen Sensor Tube
(SensO
2 Models Only)
9 or 10-Pin
Connector
(STEP 8)
Upper Mounting
Screws
ON/OFF
Switch
( )
(STEP 11)
I/O
Patient Outlet
Barbed fitting
Top and Bottom
Barbed fittings
8-Pin
Connector
(STEP 9)
Lower Mounting Screws
Control Panel
Transformer
Harness
Connector
(STEP 10)