Filter
Top Products
SECTION 7—COMPRESSOR
Platinum™Series 46 Part No 1110538
Removing the Head Cover and Valve Plate Assembly
NOTE: For this procedure, refer to FIGURE 7.10.
1. Disengage the eight Torx bolts that secure the head cover and valve plate assembly to
the compressor (Detail “A”).
2. Remove the head covers and valve plate assembly (Detail “B”).
NOTE: Notice that the outside Torx screws are longer than the inside Torx screws.
FIGURE 7.10 Removing the Head Cover and Valve Plate Assembly
Removing Head Cover Gaskets, O-Ring Gaskets,
Exhaust Valves and Limiter
NOTE: For this procedure, refer to FIGURE 7.11, FIGURE 7.11, FIGURE 7.12 on page 47, and
FIGURE 7.13 on page 47.
1. Remove and discard the old head cover gaskets on the top of the valve plate assembly.
FIGURE 7.11 Removing Head Cover Gaskets, O-Ring Gaskets, Exhaust Valves and Limiter
Head Covers
Valve Plat
e
Assembly
DETAIL “B”
Torx Bolts
Compressor
Torx Bolts
Head
Cover
Valve Plate
Assembly
DETAIL “A”
Head Cover Gasket
Head Cover Gasket
Valve Plate Assembly