Filter
Top Products
63
4. BASIC OPERATION
The T802 analyzer is a computer-controlled analyzer with a dynamic menu
interface that allows all major operations to be controlled from the front panel
touchscreen through these user-friendly menus. (A complete set of menu trees is
located in Appendix A of this manual)
This section includes Step-by-Step instructions for using the display/touchscreen
to set up and operate the analyzer's basic O
2
measurement features and functional
modes.
4.1. OVERVIEW OF OPERATING MODES
The T802 software has a variety of operating modes. Most commonly, the
analyzer will be operating in Sample Mode. In this mode a continuous read-out
of the gas concentration is displayed on the front panel. SAMPLE mode is used
to:
perform calibrations
run test functions
read and clear warning messages
output analog data (when enabled)
The next most commonly used operating mode is SETUP mode, which is used
to:
perform certain configuration operations, such as programming the DAS
system or the configurable analog output channels
set up the analyzer’s serial communication channels (RS-232, RS-485,
Ethernet)
perform various diagnostic tests during troubleshooting
07275B DCN6418