Milestone XProtect Smart Client 3.0; User’s Manual
www.milestonesys.com Page 31 Views
Thin orange border indicates hotspot
3. When the hotspot position is selected, you are able to specify its properties in the Setup
tab’s Properties section:
Image Quality: Select between Full (default), SuperHigh (for megapixel), High,
Medium or Low. The setting will apply for all cameras displayed in the hotspot.
Frame Rate: Select between Unlimited (default), Medium (25% of original frame
rate) or Low (one frame per second). The setting will apply for all cameras
displayed in the hotspot
Maintain Image Aspect Ratio: If check box is selected, the cameras’ original
image aspect ratio will be maintained; this will provide you with non-distorted
images, but may lead to black bars appearing above/below images.
If check box is cleared, images will be stretched to fit the hotspot; this may lead to
slightly distorted images, but you will avoid any black bars appearing around the
images. The setting will apply for all cameras displayed in the hotspot.
Adding Static Images
Static images can be used in views for a variety of purposes: for company logos, for including floor
plans or maps in the view, for including photos of wanted persons, etc.
Example: A map inserted in a view as a static
image
To add a static image to a view, do the following on the Setup tab:
1. Drag the System Overview section’s Image link to the required position in the view.
