Tektronix WFM 601M Wheelchair User Manual


 
Line Select Commands
C–42
WFM 601A, WFM 601E & WFM 601M User Manual
Line Select Commands
The commands in this section allow you to select the part of the video signal you
wish to display and measure. Use the command MENU LINESelect (page C–50)
to enable the Line Select functions.
LINESelect:<command> <options>
Table C–10 describes the LINESelect: commands and the argument options
associated with each command. These commands correspond to the selections
available when you press the LINE SELECT button.
LINESelect:<command> <options>
LINESelect[:<command>]?
:<command> <options>
Table C–10: LINESelect: commands and options
:<command> <options> Remarks
MODE <ON | OFF> Selects whether the Line Select mode is ON or OFF.
FMODE <ALL | TWO> Selects the mode that displays one line out of field 1
or field 2 or the same line in both fields.
FIELD <F1 | F2> Selects from which field the Line Select sample is
chosen. Select the line with the command
LINES:NUMBER and the sample with LINES:SMPL.
DISP <H1 | H15 | SAMPLE> Selects the Line Select mode from single line (H1) or
a range of 15 lines or a single sample within a line.
NUMBER <line number> Selects a particular horizontal line for Line Select.
Select the field using the command LINES:FIELD
and the sample using LINES:SMPL.
SMPL <sample> For the WFM 601M, selects a particular sample on a
horizontal line for Line Select. Select the line with
the command LINES:NUMBER and the field with
LINES:FIELD.
Syntax
Arguments