Filter
Top Products
Configuration Commands
C–6
WFM 601A, WFM 601E & WFM 601M User Manual
Configuration Commands
The commands in this section allow you make the following changes to the
waveform monitor:
H Select the source of your reference signal
H Select a specific mode for different displays (for example, select the
Lightning mode when in the Vector display)
H Set parameters for various displays
Most of these commands correspond to the selections available from the
CONFIG menu on the waveform monitor.
REFErence: MODE <INT | EXT>
Selects either the internal serial digital or external composite video for the
synchronization reference.
REFErence: MODE <INT | EXT>
REFErence: MODE?
<INT | EXT>
refe:mode int
refe:mode?
:REFERENCE:MODE INTERNAL
Syntax
Arguments
Examples
Returns