Tektronix WFM 601M Wheelchair User Manual


 
Cursor Commands
C–16
WFM 601A, WFM 601E & WFM 601M User Manual
Cursor Commands
The commands in this section allow you to select and move the voltage and
timing cursors on the waveform monitor. They also allow you to make measure-
ments using the cursors.
CURsor:SELect <VOLT | TIME | VOLT_TIME | MARK | NONE>
Enables any one of the following cursor types:
H VOLT provides two voltage cursors and a track control.
H TIME provides two time cursors and a track control.
H MARK provides three amplitude markers.
H VOLT_TIME provides both VOLT and TIME cursors. Use CUR:CONTROL
to select either the voltage or time cursors.
CURsor:SELect <VOLT | TIME | VOLT_TIME | MARK | NONE>
CURsor[:SELect]?
<VOLT | TIME | VOLT_TIME | MARK | NONE>
cur:sel volt
cur:select mark
cursor:select volt_time
cur?
:CURSOR:SELECT VOLT_TIME;CONTROL TIME
cursor:select?
:CURSOR:SELECT VOLT_TIME
Syntax
Arguments
Examples
Returns